Dispensit 1092 and 1093 Valves

The Dispensit Model 1092 & 1093 rod positive displacement valves with luer lock needles. High precision repeatable shot-to-shot (1092) and bead (1093) volumetric dispensing. For tube dispense or pinch tube dispense.

Product Enquiry

For low to high viscosity materials with various wetted component configurations for abrasive filled, or corrosive materials
1092 is a pneumatically-controlled valve with micrometer adjustable dispense volumes for accurate, repeatable shot dispensing
1093 is a servo-driven valve for programmable, precise shot or bead dispensing
Pneumatic and electronic controls can be integrated for automated applications

Features

Pnuematic drive with micrometer stroke adjustment (Model 1092). Servo motor drive (Model 1093)
Insensitive to changes in material viscosity-very thin to paste consistency.
Easily integrated with automated equipment.
Compatible with a wide variety of materials

Specification

Dispensit 1092
Maximum Ambient Temperature	43°C
Maximum Operating Temp	65°C
Maximum Outlet Fluid Working Pressure	14 MPa, 138 bar
Maximum Air Working Pressure	0.7 MPa, 7 bar
Minimum Air Working Pressure	480 kPa, 4.8 bar
Maximum Material Inlet Pressure	8 MPa, 83 bar
Plastic Sleeves: 400 psi	2.8 MPa, 28 bar
Supplied Air Requirements.	1 to 3 cfm at 80 psi to 100 psi
Shot Size Range (depending on metering rods selected)	0.024 cc to 9.600 cc
Maximum Cycle Rate (application dependent, heat required) .	Up to 60 cycles per minute
Dimensions (H x L x W), height to end of material inlet	395 mm
Height 1092-10A-4: 17.16 in.	436 mm
Height 092-10A-6: 20.28 in.	515 mm
Length, non-cycle detection: 8.38 in.	395 mm
Length, Detection: 9.13 in	232 mm
Single Needle Outlet (Standard): 1.75 in.	45 mm
Graco-supplied Feed System Assemblies (depends on selected options):
Smallest: 22.5 x 10 x 4 in.	572 x 254 x 102 mm
Largest: 60 x 28 x 19 in.	(1524 x 711 x 483 mm
Weight:
1092-10A-2	2.72-3.18 kg
1092-10A-4	4.54-4.99 kg
1092-10A-6	6.35-6.80 kg
Wetted Parts	Metering Valve: Hardened steel, 303/304, 404, UHMWPE, Tungsten, carbide, fluoroelastomer, EPDM, PTFE, Acetal. Graco-supplied Feed System Hoses and Fittings: Mild steel, 303/304, PTFE, buna, polyethylene, polypropylene. Graco-supplied Tanks: Polyethylene, 303/304, mild steel